每次開機, window內置的防火埸也沒有啟動, 我並沒有打開norton的防火埸, 不知有無兄弟可幫忙呢

引用:

原帖由 ODO3033 於 2006-8-17 12:18 PM 發表
每次開機, window內置的防火埸也沒有啟動, 我並沒有打開norton的防火埸, 不知有無兄弟可幫忙呢

你用Winodws XP ?

引用:

原帖由 mnywong 於 2006-8-17 06:15 PM 發表

你用Winodws XP ?

你係控制台 -> 防火牆 有無開到啊.

引用:

原帖由 mnywong 於 2006-8-17 06:19 PM 發表

你係控制台 -> 防火牆 有無開到啊.

or you can do the following:

1. Click Start, click Run, type Firewall.cpl, and then click OK.
2. On the General tab, click Off (not recommended), and then click OK.

I enable it every time, after I turn off the computer, and turn it on again, the firewall is not enabled.

引用:

原帖由 ODO3033 於 2006-8-18 07:38 AM 發表
I enable it every time, after I turn off the computer, and turn it on again, the firewall is not enabled.

Pls check the following value from registry:

HKLM\SYSTEM\CurrentControlSet\Services\SharedAccess\Parameters\FirewallPolicy\StandardProfile\EnableFirewall

1 = Enable
0 = disable

Pls be reminded that to close all application and backup your registry before you make any changes on it.

thanks will give it a try.

If you have SP2 the fire wall mustbe open auto.

引用:

原帖由 mnywong 於 2006-8-18 10:56 AM 發表

Pls check the following value from registry:

HKLM\SYSTEM\CurrentControlSet\Services\SharedAccess\Parameters\FirewallPolicy\StandardProfile\EnableFirewall

1 = Enable
0 = disable

Pls be r ...

Pls advise how to Check the "registry"  & obatin the following information ??  Any software that I need to EDIT the content (e.g. change the value 0 or 1 for enable or disable )

HKLM\SYSTEM\CurrentControlSet\Services\SharedAccess\Parameters\FirewallPolicy\StandardProfile\EnableFirewall

1 = Enable
0 = disable

引用:

原帖由 焦器勃勃 於 2006-8-26 08:33 AM 發表





Pls advise how to Check the "registry"  & obatin the following information ??  Any software that I need to EDIT the content (e.g. change the value 0 or 1 for enable or disab ...

Click Start => Run => Type "regedt32", the registry editor will be opened. Browse through it like a Winodws Explorer. Hope this help !