thx for sharing

thx~~~~~~~~~~~~~~~~~~

thanks for your sharing~

1323232323232323232323232323232323232323232323232323232323232

Thank you very much!

thanks a lot~

thx your share

thx for sharing

谢谢分享~~~~~~~~~

yeh yeh thanks thanks

thanks for sharing

thanks very much

（1）将所有的动刀全部装在转子上，然后用紧固螺栓
轻轻压紧。
（2）装上底层定刀，使其尽量往后退，用紧固螺栓轻
轻夹紧。以定刀为基准使动刀和定刀之间的间隙用顶
刀螺钉调整在0.3-0.5mm范围内，其余动刀也以此定
刀为基准调整刀隙，使之在0.3-0.5mm范围内。
（3）将所有的动刀和定刀压紧后，再调整顶刀螺钉，使所有的刀具顶紧即可。

thank for sharing.

thanks for sharing

see see see see see see see see see see see see see see see see

好野一定要支持~~~~~~~~~~~~~~~~~~